Detection of Failures in Metal Oxide Surge Arresters Using Frequency Response Analysis.

This work presents an innovative application of Frequency Response Analysis (FRA) in order to detect early degradation of Metal Oxide Surge Arresters (MOSAs). This technique has been widely used in power transformers, but has never been applied to MOSAs. It consists in comparisons of spectra, measured at different instants of the lifetime of the arrester. Differences between these spectra are an indicator that some electrical properties of the arrester have changed. An incremental deterioration test has been performed on arrester samples (with controlled circulation of leakage current, which increases the energy dissipation over the device), and the FRA spectra correctly identified the progression of damage. Although preliminary, the FRA results seemed promising, and it is expected that this technology could be used as another diagnostic tool for arresters.

Online Frequency Response Analysis of Electric Machinery through an Active Coupling System Based on Power Electronics.

This paper presents an innovative concept for the online application of Frequency Response Analysis (FRA). FRA is a well known technique that is applied to detect damage in electric machinery. As an offline technique, the machine under testing has to be removed from service-which may cause loss of production. Experimental adaptations of FRA to online operation are usually based on the use of passive high pass coupling-which, ideally, should provide attenuation to the grid voltage, and at the same time, allow the high frequency FRA signals to be injected at the machine. In practice, however, the passive coupling results in a trade-off between the required attenuation and the useful area obtained at the FRA spectra. This paper proposes the use of an active coupling system, based on power electronics, in order to cancel the grid voltage at the terminals of FRA equipment and allow its safe connection to an energized machine. The paper presents the basic concepts of FRA and the issue of online measurements. It also presents basic concepts about power electronics converters and the operating principles of the Modular Multilevel Converter, which enables the generation of an output voltage with low THD, which is important for tracking the grid voltage with minimum error.

An Ultrasonic-Capacitive System for Online Characterization of Fuel Oils in Thermal Power Plants.

This paper presents a ultrasonic-capacitive system for online analysis of the quality of fuel oils (FO), which are widely used to produce electric energy in Thermal Power Plants (TPP) due to their elevated heating value. The heating value, in turn, is linked to the quality of the fuel (i.e., the density and the amount of contaminants, such as water). Therefore, the analysis of the quality is of great importance for TPPs, either in order to avoid a decrease in generated power or in order to avoid damage to the TPP equipment. The proposed system is composed of two main strategies: a capacitive system (in order to estimate the water content in the fuel) and an ultrasonic system (in order to estimate the density). The conjunction of the two strategies is used in order to estimate the heating value of the fuel, online, as it passes through the pipeline and is an important tool for the TPP in order to detect counterfeit fuel. In addition, the ultrasonic system allows the estimation of the flow rate through the pipeline, hence estimating the amount of oil transferred and obtaining the total mass transferred as a feature of the system. Experimental results are provided for both sensors installed in a TPP in Brazil.

Recent Research and Development of Microgrids in Parana

Abstract Microgrids (MGs) have increasingly attracted the attention of researchers, government officials, and electricity companies for the values and services they can add to the grid. They can operate independently as a single controllable unit in a coordinated way while connected or islanded, which make them suitable to integrate the growing amount of distributed energy resources (DERs) into the distribution network (DN). An active distribution network with high penetration of DERs could be redefined into a collection of microgrids in different layers, pooling their resources together to enhance the grid's performance in the sense of electricity as a service. However, enabling a microgrid-based power system infrastructure poses challenges concerning operation and control. In this paper, a comprehensive overview of research topics regarding microgrid operation are shown in a hierarchical or stratified manner, looking for a holistic vision of a microgrid-based distribution system. First, multi-objective optimization within one microgrid is formulated aiming to minimize costs and maximize battery life is presented. Second, the interaction among MGs, DERs and the DN was modeled using the OPF technique to represent the operation of the grid as a whole. Following, a methodology for collaborative optimization of multiple MGs operating together is presented and at last a theoretical framework for MG operation through decentralized energy markets is discussed. As a result, this paper aims to contribute to a broad vision of the distribution system based on microgrid operation in all its levels.

Projects for predictive maintenance and operation between Copet G&T and Gnarus Institute

Abstract The continuity of an electrical system's services is linked to its equipment's correct operation. The more correctly they worked, the higher the quality of the services provided. Thus, they must have their functioning scanned closely and that minor defects have their evolution monitored. This fact creates the possibility of making predictions about how long equipment can operate without compromising the system's continuity. This follow-up is proper for predictive maintenance. This paper presents three on-going COPEL Generation and Transmission projects in essential elements of its electrical system: circuit breakers, lightning arresters, and SF6 substation. The central idea of all monitoring projects is to check the early problem in this equipment and facilities.

Virtual Reality Applied in a Thermoelectric Power Plant Planning

Abstract The planning of a new thermal power plant is linked to the various decision elements and evaluation criteria. Factors such as the plant's geographic positioning, primary energy supply points, paths, and means of delivery of this primary energy should be analyzed. Similar studies are imposed when studying the change of a thermoelectric plant's primary energy source occurs. In Brazil, several plants are currently investigating the exchange of their primary fuel from oil to gas due to the decrees issued by ANEEL. This paper presents software, which uses virtual reality to assist in the various stages of the planning process and in the analyses that must be performed. This software was developed for the Hidrotermica Group and had as the primary target the Borborema Thermoelectric Power Plant.

Intelligent System for Dispatch Ranking of Generating Units in Thermoelectric Power-Plants

Abstract The multicriteria decision-making process is still an open problem, especially when the decision criteria are not numerical or fully outlined. Several numerical, intelligent, or hybrid techniques have been developed, creating contributions to this problem's solution. This paper is another step in this direction. Based on the Modified Analytic Hierarchy Process (MAHP), a methodology for diagnosis and performance analysis is presented for the dispatch ranking of generating units in a thermoelectric plant. The problem is complex because it covers a power plant, where 99 generating units may be dispatched, according to 10 possible evaluation criteria, which should be used together. This article also presents details of the implementation of the sensors necessary to add to the supervisory system existing in the Palmeiras de Goias Thermal Power Plant.